Don't need a hammer, you know how to disassemble the bearing

(5) Check after installing the bearing.

The spherical roller bearing bearing package is opened before the installation. Lubricating oil is not necessary for cleaning. However, for instruments or high-speed bearings, it should be cleaned with clean oil to remove the rust inhibitor applied to the bearing. Generally grease is lubricated, not cleaned, and directly filled with grease. Furthermore, bearings that have been sealed with grease are used without cleaning. The bearing with the rust preventive removed is easy to rust, so it cannot be placed. When installed in the outer casing, the general clearance fits a lot, and the outer ring has an interference amount, which is usually pressed by a press or a cold shrink fit method after cooling. When dry ice is used as a coolant and cold shrinkage is installed, the moisture in the air will condense on the surface of the thrust spherical roller bearing. Therefore, appropriate rust prevention measures are required.

After continuing to run, the vibration and noise of the spherical roller bearing begin to increase, and sometimes the abnormal sound appears, but the change of the vibration increases slowly. At this time, the bearing kurtness value suddenly reaches a certain value. We believe that the bearing is an initial failure at this time.

At this time, it is required to closely monitor the spherical roller bearing and pay close attention to the change. After that, the bearing kurtosis value begins to drop rapidly and approaches the normal value, while the vibration and noise begin to increase significantly, and the increase rate begins to accelerate. When the vibration exceeds the vibration standard (such as ISO2372 standard), the bearing kurtosis value also begins. Rapid increase, when both the vibration standard and the kurtosis value exceed the normal value (the available kurtosis relative standard), we believe that the bearing has entered the late fault production, it is necessary to repair the equipment in time and replace the bearing.

The bearing exhibits late fault characteristics to serious faults (generally bearing damage such as axle hung, burn, sand frame spalling, raceway, bead wear, etc.). The time is not more than one week. The larger the equipment capacity, the faster the speed. The shorter the interval. Therefore, in the actual bearing fault diagnosis, once the late fault characteristics are found, the thrust of the thrust spherical roller bearing bearing should be judged decisively, and the maintenance should be arranged as soon as possible.